Error: "Invalid currency pair" (emotionless)

[Cisco]

Hi there,

I,m running the Gunbot 12.9.2 version (23 May) / emotionless on Poloniex.
Following "Invalid currency pair" message appears:

-----------------------------------

All good...keep calm and Gunbot.

GBRT_v12.9.9.2 BTC-ATOM@poloniex Round #1 2019/06/03 19:59:45

All good...keep calm and Gunbot.

GBRT_v12.9.9.2 BTC-ETH@poloniex Round #2 2019/06/03 20:00:06

All good...keep calm and Gunbot.
"Invalid currency pair."
Error: Invalid currency pair.
    at errorHandler (C:\snapshot\gblackv12\ctx\js\poloniex.js:0:0)
    at <anonymous>
    at process._tickCallback (internal/process/next_tick.js:188:7)

(Code 14904)Requesting data...please wait...

(Code 14911)Requesting data...please wait...

GBRT_v12.9.9.2 BTC-DASH@poloniex Round #2 2019/06/03 20:00:36

All good...keep calm and Gunbot.

GBRT_v12.9.9.2 BTC-DGB@poloniex Round #2 2019/06/03 20:00:57

All good...keep calm and Gunbot.

GBRT_v12.9.9.2 BTC-ETC@poloniex Round #2 2019/06/03 20:01:16

All good...keep calm and Gunbot.

GBRT_v12.9.9.2 BTC-LTC@poloniex Round #2 2019/06/03 20:01:34

-----------------------------------

Message appears after the "GBRT_v12.9.9.2 BTC-ETH@poloniex" reading 
Even when I disable ETH the message appears.
Anyone have an idea.....?

Kind regards,
John

[Aitor]

Hi, try removing BTC-ATOM

[Cisco]

Hi, try removing BTC-ATOM

Unfortunatly, disabled it, removed it, did'nt work..

[Aitor]

I would try something:

Remove all the pairs. Then add this one: BTC-LTC

Be sure to add it same way as I put it above (copy & paste). Always CAPS, avoid to put blank spaces, be sure to use - between BTC and LTC and not –

It should work. Then add other pair and try again, and add 1 by 1, so you can see which pair is causing the problem. Anyway, if you add existing pairs, using CAPS and taking care of "-", blank spaces or any other unwanted simbol, everything should be fine.

[Cisco]

I would try something:

Remove all the pairs. Then add this one: BTC-LTC

Be sure to add it same way as I put it above (copy & paste). Always CAPS, avoid to put blank spaces, be sure to use - between BTC and LTC and not –

It should work. Then add other pair and try again, and add 1 by 1, so you can see which pair is causing the problem. Anyway, if you add existing pairs, using CAPS and taking care of "-", blank spaces or any other unwanted simbol, everything should be fine.

Thanks for the respons, I know what you mean and I will look in to this.

Kind regards,
John

[Cisco]

I disabled all pairs except for one, the message did'nt show up anymore.
Then I discovered that I had BCH running, the coin has been frozen for a while and made a switch to BCHABC & BCHSV, I just did'nt added it the right way.
Thanks for the support, its working fine now...

Kind regards,
John