2 instances of gunbot !?

[magictrade]

hello together,

how can i run two instances of gunbot ?

becouse i have two accounts on kraken, one for /usd and one for /btc.

i think it is not possible to usw two accounts of one exchange with one instance ?

so i try to run two (change the ports and ip).
i can config both, at the same time, but iam not shure if they both work together, becouse if i click "run" than only in one log-window something is shown....

and only one gunthy.exe is running.......


please help me 

nobody give me an answer via pm or telegram 

[magictrade]

ok, maybe it work, if i run the gunthy.exe direct .......
but it dont work in the browser-window.

and there is another bug, i sometimes dont can close the gunthy.exe, only after a reboot......

[sloaleks]

you need to set up two bots, in two folders. each of the bots must get its own port, you can configure this. also you need both APIs verified for your gunbot.
when you have this, start each bots exe file from each of the folders, voila.

[magictrade]

thank you !

it work now, it was a little bit confusing with the ports and with the gui and so on, but i have config each bot and than only start the guntthy.exe and now it work (;

[arranka]

have you managed to open it from guntthy-gui.exe
try to change the port with a bat but I can enter the graphical interface, when giving rum wants to connect to port 5000
and this port 5000 is already in use by the first bot

[sloaleks]

wiki, advanced setup describes how to change the GUI port.

[dobcrypto]

have you managed to open it from guntthy-gui.exe
try to change the port with a bat but I can enter the graphical interface, when giving rum wants to connect to port 5000
and this port 5000 is already in use by the first bot

https://gunbot.shop/run-multiple-instances-of-gunbot-and-change-ports/
better to run more then 1 bot without GUI

[caleonardo]

Hi, I followed the instructions below and was able setup 2 ports and run (2 instances of gunbot and open them both on firefox. I am not sure if the 2nd bot is running though, there is no log displayed even though the log is turned on. How to display the log or does it not only display for the first bot?

[sloaleks]

you can not run two bots in the GUI. The GUI can be used for quick set up, but you must close the GUI after setup and start and run each bot with its exe.

[yosal]

you can run two or more bots if you dockerise them (put each in a separate docker container)