Username: Password:

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - sbogovac

Pages: [1] 2 3 ... 6
General Discussion / Re: Uncontactable - refund me please
« on: October 16, 2021, 08:19:10 AM »
1. I paid for gunbot - receipt 1631907733026-1KoCzpGqr4SVTGGh1ev3Um4KVg67K3bjSZ - this was one month ago
2. Paid to: 1KoCzpGqr4SVTGGh1ev3Um4KVg67K3bjSZ
3. I've emailed a number of times, not a single response
4. I'd like a refund please, I no longer want access after all of this. Please pay to BTC: bc1qpe568a7ppkusmkcn3ycutshe3msr7k6d5gnsaw

Thank you

Who was your reseller?

List of official resellers:

General Discussion / Re: Accessing the training
« on: August 24, 2021, 09:05:48 AM »
Hi All - I am new and purchased Gun bot via a reseller.  I am trying to work out how I can access the training materials on site.

Your reseller should invite (and guide) you.

That's not a solution. The problem is that when a bag DCA's into a break-even sell, it frees up funds and, depending on the market, it might buy the coin again.

Say for example I got a bag of ETH right now. I add funds, it DCA's, the marketprice rises, Gunbot decides it's time to sell, now I've got even more funds. Now the rest of the market does nothing, so my ADA, DOT and LINK don't DCA. ETH follows by dropping 3% and Gunbot decides to buy. Gone are my funds to DCA and clear bags on other alts.

I want to allow DCA, but don't want to allow filling empty bags. As Gunbot is, should be, automated software, I feel it's incorrect to be required to check every few hours if it sold a bag.

Yes, and then you re-enable them...?

Gunbot is an automator, not AI... it's not like when you install MS Word your PC starts writing bestsellers for you, is it?

If you want, you can write your own AutoConfig to do the dis-/enabling for you:

Automated config changes for Gunbot. Enables you to automatically add or remove trading pairs, or change pair overrides - using filter criteria you define.

Ever since all markets crashed 40-70%, Gunbot hasn't been doing anything anymore. I've got bags and my wallet doesn't have any change to buy more to DCA. I don't mind putting in a few fiat to allow some DCA. But I don't want Gunbot to buy 'new' coins, only DCA.

Is there a simple way to allow DCA-buying, but disallow buying new coins for which are configured, but you don't have any bags yet?

Remove/disable those coins first (before adding funds)...?

Technical Support & Development / Re: [ERROR] Kucoin Not Exist
« on: June 07, 2021, 08:16:13 AM »
Good morning,

I've been using Gunbot V22 with no issues for the past month or so, trading on KuCoin. This morning I woke up and discovered the bot has stopped trading and gave me the following error message: [...]

I do not use KuCoin myself, any more, but I saw some discussions about KuCoin being broken and a fast fix by Gunthar in the Telegram channels last night. I believe a fix (Gunbot v22.0.2.3) has been posted on the ANN channel.

Beginners & Help / Re: PNL only showing USD (incorrectly)
« on: June 02, 2021, 10:32:53 AM »
Hello all, I am relatively new user after having a 3 year break from GunBot (dumb decision).  I'm loving the new version but have a question about the PNL - after running the bot for about a week on very small trades, it shows "Total Profit   0.00028439 USD" however from what I can figure this should be BTC rather than USD.  I'm guessing it is user error and there is something I should be changing, but can't search/find what I'm after.  Any assistance appreciated.

Unfortunately it's no "user error"... it's a known issue, and being worked on as we speak.

Thank you.  We are in contact, he's super smart and incredibly helpful, but we still can't figure it out.  What I've found is that I believe the core is having an issue. [...]

Then you or your reseller can report a #corefix at the appropriate Telegram channel:
1.- strictly running the latest build from announcement channel;
2.- provide config.js (save export without private info);
3.- provide the state.json file of the pair;
4.- provide and extra description you think is useful for us; and,
5.- tag your reports with #corefix.

I would advice to contact your reseller for primary support.

Technical Support & Development / Re: Don't connect binance
« on: May 17, 2021, 07:44:35 AM »
I just bought a key version V12, now I'm setting it up. I followed the intructions from the video (tu dien link). I added BTC-ETH, instead of turning them on, I clicked "start bot" to check its connection to binance. Then I saw no connection like what was in the video, but spotted a notification on screen in the attached image . And it fell into the repeating circle, consecutively reconnected and still had no connection to binance. Could you please give me some solution to this problem? I'm looking forward to hearing from you.

You reseller is your first point of contact to get you going/started...

From the error message though I'm presuming there's an error in the pair naming. Did you add it through the GUI?

But v12? Are you sure? Or am I misreading something ("key version")? We're on v22 at the moment...

General Discussion / Re: Proft/Loss not calculated
« on: May 10, 2021, 07:54:30 AM »
Yes, the PNL calculations are off. It is a known issue and being worked on as we speak...

Beginners & Help / Re: How to Recover my Gunbot license
« on: May 06, 2021, 02:02:51 PM »
I contacted admin after read this post! Thanks

Dear Supporter!
I had buy a Gunbot Unlimited for a Long time (2017)
After Bitcoin falling down, i stop using gunbot.
Now i want to use it again
but i can not contact to last Resller. They are (This website is shutdown)

Now i have all information in email.
How can i recover my license. Please Help. Thanks

Do you use Telegram? I think the admin of this forum (@AitorRuiz) should be able to point you in the right direction...

I am also getting an error in futures. signals and other signals have errors.  Can you send me the version suitable for futures?  [editedout]

First: please, PLEASE delete your email address from this public website... enough scrapers running around for collecting them.

Second: latest version just got released at:

Technical Support & Development / Re: Tradingview Alert
« on: May 05, 2021, 10:12:23 PM »
[...] I can't reach my gunbot seller (fuathan). Should I write here when I want support. Or are there other channels?

Who is your reseller? I cannot seem to find any "fuathan" on the list of resellers:

There are other channels (like telegram and wiki), but your reseller should point them out to you...


can you please implement placing LIMIT SELL ORDER (% GAIN) immediately after bot bought.

I'm running 200+ pairs on binance and since it takes 4 seconds to process 1 pair it takes 10+ minutes to cycle to the same pair.

Other than that the bot is perfect. Thanks

You could try to break up your pairs over several instances:

HFT (High Frequency Trading) coming up in coming releases...


can you please implement placing LIMIT SELL ORDER (% GAIN) immediately after bot bought.

I'm running 200+ pairs on binance and since it takes 4 seconds to process 1 pair it takes 10+ minutes to cycle to the same pair.

Other than that the bot is perfect. Thanks

You could try to break up your pairs over several instances:

HFT (High Frequency Trading) coming up in coming releases...

Hi all,

I had briefly activated RT selling. The bot also worked. After turning off the RT selling the bag was also at 0. But now the bot still believes to have bags available and buys therefore no longer.

What can I do to fix this error.
Can I reset that.

RT is something that is difficult to master. Basically the advice is to set up RT only at the beginning of a pair/strategy... if you do it in the middle of trading then things can get messed up pretty much. I quote: "Do not activate reversal trading on existing bags that are already down a lot unless you useTM_RT_SELL! The decision to run reversal trading or not should best be made before you start trading a pair, this way the process can kick in timely."

You can "start over" by using Ignore_trades_before and set there.

General Discussion / Re: So.. When is the next update?
« on: April 16, 2021, 04:38:41 PM »
[...] But seems very silent around here.

Running V21.

That's because patches are published in the Telegram announcement channel... We're on Gunbot v21.8.4 there now.

Maybe you should ask your reseller for an invite (over there)..?

Does anyone know where to contact customer support or email to confirm my purchase? I purchased online on their official website the starter paid by btc but I dont have any email response yet since you will have details when your purchase was successful.

You purchased at what reseller('s website) exactly?

Here's a list of official resellers.

Good morning,

Are there issues with the gunbotserver?
Gunbot is spitting errors, I think due to Error: connect ECONNREFUSED
It worked fine untill i rebooted the bot.


Yes, the license server was down. Should be working now.

Technical Support & Development / Re: help needed Register old buy
« on: March 04, 2021, 10:39:28 AM »
Hi, bought Gunbot XT Edition core (Gunthy GUI, all Exchanges, TradingView Release) back in 12/2017 for 0.10BTC but never come around to install it.
I do have the purchase tx id and only one of the bunch of API keys i send in still does exist and work.

How do i proceed from here with current Gunbot versions, which one would i download and would i run into verification problems?

You contact Aitor (admin on this forum) ar wait for him to react publicly here... but DO NOT react to PM's you get, especially from people asking for additional payments to "help" you. Chances are (big) they are scammers...

Pages: [1] 2 3 ... 6