Messages

1

Technical Support & Development / Re: Feature Requests & Suggestions for Gunbot

« on: June 18, 2017, 04:44:52 PM »

Volume Analysis and auto off/on on trading that pair feature for pairs under 300 volume (poloniex)

Would be helpful to have a way to keep the bot running on all the pairs, but turn off the trading capabilities if the volume falls under a threshold set. In the event that you have an open trade, it would still keep the pair running until a sell point is reached.

2

General Discussion / Re: Request for a third party site or software with "best currencies"

« on: June 18, 2017, 04:30:58 PM »

You can use the node currencies from the 3.1 package.

3

Technical Support & Development / Feature Request for gadd - Add ETH_XXX and XMR_XXX pairs

« on: June 08, 2017, 05:21:08 PM »

Would it be possible to add to the gadd feature in gb to be able to pick the base crypto and designate which exchange it's on.
Right now, from my understanding we can can only add BTC_XXX from the gadd command.

It would be great if we could add the ETH_XXX and the XMR_XXX pairs from the gadd command, as well as designate which exchange they should be on.

Thank you. 

4

Beginners & Help / Re: [TUT] How to running GUNBOT in Linux

« on: June 08, 2017, 04:21:44 PM »

Thanks for this tutorial, extremely helpful for the 'nix crowd on here.

Questions pertaining to getting pairs loaded up through the pm2 module on the bittrex exchange:

1) How would I load a pair on the bittrex exchange using the pm2 module? I would need to have a separate bittrex-BTC_XXX-config.js from the polo config?

2) Could I run the same pair on polo and bit simultaneously on pm2 with the separate config files? (i.e. BTC_XXX on polo & BTC_XXX on bit)

3) I'm trying to add an ETH_XXX pair through the 'pm2 start ETH_XXX' the config files are in the correct directory, but I'm receiving the error 'Script not found' per the screenshoot. Any suggestions on what I am doing wrong so I can get that to work?