Username: Password:

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - razzor

Pages: [1]
1
General Discussion / Re: Gunbot XT 7.0.2 Stoped working (cryptopia)
« on: January 01, 2018, 03:13:49 PM »
cryptopia fixed it !!

Happy new year!!

And Happy botting !!

2
General Discussion / Re: Gunbot XT 7.0.2 Stoped working (cryptopia)
« on: December 31, 2017, 01:51:32 PM »
i found this on the cryptopia  forum it looks like the certificate is not complete

https://www.cryptopia.co.nz/Forum/Thread/4351

maybe we have to wait, the workarrounds look complicated

 at least its not my bad:)

3
General Discussion / Gunbot XT 7.0.2 Stoped working (cryptopia)
« on: December 31, 2017, 12:35:51 PM »
Hi all ,
i have finaly expand my license to all exchanges, a couple of days ago, and y managed to install it on poloniex and bitfinex without isues but on cryptopia it wasnt ok from the start, at first when it says it was going to sell it doesnt, so i have to manual sell, and now it shows me this error

(node:2956) UnhandledPromiseRejectionWarning: Unhandled promise rejection (rejection id: 1): Error: unable to verify the first certificate
(node:2956) [DEP0018] DeprecationWarning: Unhandled promise rejections are deprecated. In the future, promise rejections that are not handled will terminate the Node.js process with a non-zero exit code.

can i be doing something wrong??

i reinstall gunbot and only put the api key and a pair to see if it works but have the same error.

Can it be a ban??

any advice is welcome

thanks in advance

4
General Discussion / Re: Gunbot XT Edition + Gunthy GUI
« on: December 26, 2017, 11:20:25 PM »
Hi all
Where can i buy the expansion of my licence you are promoting for xmas
i cant find a way, any link?
Thanks

5
General Discussion / Re: Next release?
« on: November 06, 2017, 09:18:34 PM »
a found a new one on youtube but y dont trust to install from that source

   https://www.youtube.com/watch?v=sPM-h_Y8Mhc

still using 3.3

Pages: [1]