41
Technical Support & Development / Re: Constructive ideas for TA use in Gunbot
« on: August 21, 2017, 08:59:59 AM »
I'm not sure how to best handle this (which TA's), but it seems logical that in order to maximize profits we would want to select pairs with sufficient volume, highest volatility, and highest percentage swings of that volatility. These should be able to be determined with various TA. Something built in along the lines of what Chirag Mehta has done here... http://botgen.io/#/
This request is probably outside the scope of Gunthar's request for TA suggestions but what is needed is a way to identify pre pump conditions, steady or slightly increasing volumes over time, walls being put up, etc. If Gunbot could identify these "storms" before they hit, then an option to auto enable that pair could trigger with predefined pump settings.
The last "market condition" would be difficult I think to pull off, if Gunbot could see SMA 50 on chart of Global Market Cap then sentiment could be determined by if SMA 50 is underneath then trend is up and market is good, if SMA 50 is above then trend is down and market is bad. This is eye candy but would be a nice overall signal to have.
This request is probably outside the scope of Gunthar's request for TA suggestions but what is needed is a way to identify pre pump conditions, steady or slightly increasing volumes over time, walls being put up, etc. If Gunbot could identify these "storms" before they hit, then an option to auto enable that pair could trigger with predefined pump settings.
The last "market condition" would be difficult I think to pull off, if Gunbot could see SMA 50 on chart of Global Market Cap then sentiment could be determined by if SMA 50 is underneath then trend is up and market is good, if SMA 50 is above then trend is down and market is bad. This is eye candy but would be a nice overall signal to have.